CMS meets your needs for hammers with a wide variety of shapes, widths, and hole sizes.
 |
CMS manufactures our own hammers. We machine drill each hole and then deburr both sides to assure a satin finish. Drilling is far superior to a stamped (punched) hole, as a stamped hole tends to make a hammer swing off center and cause premature rod wear. |
|
They are case hardened to 54 Rockwell C (±2). Each hammer is individually weighed and most sets are sold evenly weighted. When necessary, we rod balance the hammers within one-tenth of an ounce. The hammers are color coded for each rod and installation instructions are included with each set. Hammers are made out of Special Alloy Steel. These same alloys are used by the largest agricultural manufacturers for plow points and draw bars. |
